LINES

Post date: Mar 16, 2013 9:7:23 PM

This is a modification of my WEB filter that helps you create lines and sheets of connective blocks in MCEdit.

LINES v3 allows the new sheets to be in a specific block type, not just determined by the end points.

Say you have a couple of different wall sections and a gap between. This filter simplifies filling in the blocks between the two.

Take the following example. Here is a dome with a regular wall section beneath it. There is a gap between. To fill in the gap would take a long time and will be very irregular.

Instead, create a selection box with the blocks above and below all within it. Then simply run the LINES filter attached below.